仿木护栏的正确安装_行业动态_新闻资讯-济南鑫路通新型建材有限公司

项目分类Project classification

资讯Information

联系我们Information

济南鑫路通新型建材有限公司
地址：济南市章丘区枣园街道办事处吉祥工业园

仿木护栏的正确安装

来源：http://www.jnxltjc.com/ 日期：2023-03-20 发布人：admin

说到仿木护栏的安装，看似很简单，但如果不注意，仿木护栏就会出现一高一低，影响美观，不牢固。那么如何安装仿木护栏呢?山东仿木护栏厂家为您分析：

When it comes to the installation of imitation wood guardrails, it seems very simple, but if you don't pay attention, the imitation wood guardrails will appear high and low, affecting their appearance and being unstable. So how to install imitation wood guardrails? Shandong imitation wood guardrail manufacturer analyzes for you:

一、立柱的预埋孔位：先由工程施工方将地面基础按尺寸标注做好预埋孔，预留好分隔柱的安装孔

1、 Location of embedded holes for columns: The engineering construction party shall first mark the ground foundation with embedded holes according to dimensions, and reserve the installation holes for the separation columns

土质地基挖孔深度30公分，水泥地基挖孔深度20公分，测量中心距，依次做预埋孔

The depth of hole excavation for soil foundation is 30cm, and the depth of hole excavation for cement foundation is 20cm. Measure the center distance, and make embedded holes in turn

二、立柱安装：当地请普通小工，先放好水平线，确认水平线是否垂直，再将立柱放入洞口固定，在预留的安装孔上安装分隔柱，安装时注意分隔柱的垂直度，并用水泥砂浆灌浆结实。

2、 Column installation: Local ordinary workers are invited to set out the horizontal line first, confirm whether the horizontal line is vertical, and then place the column in the hole for fixation. Install the separation column on the reserved installation hole. During installation, pay attention to the verticality of the separation column, and grout it firmly with cement mortar.

1、土质地基灌混凝土10公分厚，水泥地基不需要灌；

1. The soil foundation is filled with concrete with a thickness of 10 centimeters, and the cement foundation does not need to be filled;

2、安装起步柱；

2. Install the starting post;
山东仿木护栏

3、安装校正柱；

3. Install the correction column;

4、放线校正垂直度和平行度；

4. Setting out to correct perpendicularity and parallelism;

5、安装第二个立柱；

5. Install the second column;

三、栏杆安装：两边立柱固定好后，再将栏杆的造型栏板嵌入到立柱的预留洞口内组装固定，栏板一般可预埋3-5cm；

3、 Railing installation: After the columns on both sides are fixed, insert the modeling fence board of the railing into the reserved hole of the column for assembly and fixation. The fence board can generally be embedded for 3-5 cm;

安装横梁，安装时注意整体水平度。

Install the cross beam and pay attention to the overall levelness during installation.

四、将所有立柱和栏板、横梁全部组装好后，用水泥砂浆将预留的洞口填平固定；

4、 After assembling all columns, breast boards, and beams, fill and fix the reserved openings with cement mortar;

1、重复第三步，依次类推安装；

1. Repeat the third step and install it in sequence;

2、用水泥和801胶水混合补缝；

2. Mix cement and 801 glue to fill the joint;

五、全部固定好后，需做清洁清理工作，若安装时，砂浆等溅到产品表面上，应及时以水刷拭干净，以防粘附在产品表面，影响产品表面美观。现场喷涂户外油漆即可呈现很好效果。安装完毕及时清理安装现场。

5、 After all are fixed, it is necessary to perform cleaning work. If mortar or the like splashes onto the product surface during installation, it should be promptly wiped with water to prevent adhesion to the product surface and affecting the appearance of the product surface. Spraying outdoor paint on site can achieve good results. Clean the installation site timely after installation.

安装前需要对运到工地的仿木护栏立柱、分隔柱、栏杆、横梁等构件进行一一检查，检查构件在运输、堆放过程中是否变形，检查尺寸是否符合要求。更多相关事项就来我们网站http://www.jnxltjc.com咨询！

Before installation, it is necessary to inspect the wooden guardrail columns, partition columns, railings, beams, and other components transported to the construction site one by one, to check whether the components are deformed during transportation and stacking, and to check whether the dimensions meet the requirements. For more related matters, please visit our website http://www.jnxltjc.com consulting service

Related products相关新闻