欢迎您访问济南鑫路通新型建材有限公司网站!

PC路沿石的安装形式及施工要求

PC路沿石的形式有立式,斜式和平式等。在路沿石上行走,既简单又有效的步行方法来调节身体的五脏六腑平衡,既可增加乐趣,又可防病治病,,起到保障行人、车辆交通和保证路面沿缘整齐的作用。下面来讲讲山东PC路沿石的安装形式及施工要求。
The forms of PC curbstone include vertical, inclined, and flat stones. Walking on curbstones is a simple and effective method of walking to regulate the balance of the body's internal organs. It can not only increase fun, but also prevent and treat diseases, prolong life, protect pedestrian and vehicle traffic safety, and ensure the neatness of the road edges. Next, let's talk about the installation form and construction requirements of PC road curb stones in Shandong.
材质要求
Material requirements
路沿石石料采用质地均匀的麻石机械切削加工而成,石材的强度必须合格,要求其色泽均匀,表面无裂纹,棱角完整,外观一致,无明显斑点、色差,不允许有风化现象,装卸时不准摔、砸、撞、碰,以免造成损伤。
The stone along the road shall be mechanically cut and processed with a uniform texture of hemp stone. The strength of the stone must be qualified, and it is required to have a uniform color, no cracks on the surface, complete edges and corners, consistent appearance, no obvious spots, color differences, and no weathering phenomenon. During loading and unloading, it is not allowed to drop, hit, bump, or collide to avoid damage.
加工要求
Processing requirements
按统一长度进行下料,外露面必须机切抛光,长度允许误差在±20mm范围内,宽度、厚度、高度允许误差在±2mm范围内。
Blanking shall be carried out according to a uniform length, and the exposed surface must be machined and polished. The allowable error in length shall be within ± 20mm, and the allowable error in width, thickness, and height shall be within ± 2mm.
山东PC路沿石
施工要求
Construction requirements
1.路沿石必须挂通线进行施工,按侧平面顶面示高标线绷紧,按线码砌侧平石,侧平石要安正,切忌前仰后合,侧面顶线顺直圆滑平顺,无高低错牙现象,平面无上下错台、内外错牙现象。
1. The curbstone must be constructed by hanging a through line, and tightened according to the elevation mark line shown on the top surface of the side plane. The side flat stone should be built according to the line code. The side flat stone should be installed correctly, and it is strictly prohibited to recline in front of each other. The side top line should be straight, smooth, and smooth, without high and low misalignment, and the plane should be free of up and down misalignment, internal and external misalignment.
2.路沿石必须座浆砌筑,座浆必须密实,严禁塞缝砌筑;
2. The curbstone must be built with mortar, and the mortar must be dense. It is strictly prohibited to build with caulking;
3.路沿石接缝处错位不超过1mm;侧石和平石必须在中间均匀错缝。
3. The dislocation at the joint of the road edge stone shall not exceed 1mm; The side stones and flat stones must be evenly staggered in the middle.
4.路沿石侧平石应保证尺寸和光洁度满足设计要求。外观美观,对弯道部分侧石应按设计半径专门加工弯道石,砌筑时保证线形流畅、圆顺、拼缝紧密。弧形侧石必须人工精凿后抛光处理。
4. The size and finish of the side flat stones along the road edge shall meet the design requirements. The appearance is beautiful, and the side stones in the curve should be specially processed according to the design radius. During masonry, ensure smooth and smooth alignment, roundness, and tight seams. Arc-shaped side stones must be carefully chiseled and polished manually.
5.路沿石后背应还土夯实,夯实宽度不小于50mm,厚度不小于15mm。
5. The back of the curbstone shall be backfilled and compacted with a compaction width of not less than 50mm and a thickness of not less than 15mm.
6.路沿石勾缝:勾缝时必须再挂线,把侧石缝内的杂物剔除干净,用水润湿,然后用1:2.5水泥砂浆灌缝填实勾干。
6. Pointing of road edge stones: When pointing, the line must be hung again, the debris in the side stone joints must be removed, wetted with water, and then filled with 1:2.5 cement mortar to dry.
7.侧平石勾缝、安砌后适当浇水养护。
7. After pointing and installation of side flat stones, water them properly for curing.
从路面基层挖槽、安装、路沿石背覆加固介绍了路沿石的施工工艺,并总结了路沿石的质量要求及注意事项,以期保证施工质量,提高道路美观性。更多事项就来我们网站http://www.jnxltjc.com咨询吧!
This paper introduces the construction technology of road edge stones from the aspects of road base excavation, installation, and reinforcement of road edge stones, and summarizes the quality requirements and precautions for road edge stones in order to ensure the construction quality and improve the aesthetics of the road. For more information, please visit our website http://www.jnxltjc.com Consult!

联系
客服

13953119885
客服服务热线

微信
沟通

扫码微信沟通
顶部
X

截屏,微信识别二维码